SPEEDWAY OIL/GREASE SEALS PART# HELP ?

shane2290

shane2290

Well-Known Member
Supporting Member
Googling my face off looking for a cross reference on these grease seals. Was a kit put on Cody's 34 from speedway of course --early Ford 40's spindles and GM rotors

speedway # is S18562 ---measure 1.875 x 2.562 x 0.313

anyone have a national number for these? timken ?

Cheers
 
Shane, check these numbers:
Napa/SKF 19984
Or
CR 19984
Or
National 8871
No gaurentee, as these numbers are in our Model A book. This car uses ‘49-‘54 Chevy modified spindles (Mr Roadster, Speedway kit).
 
I just picked up seals through Lordco, now open in Red Deer! The aftermarket taper roller bearing kits for the 55 (‘55-‘59) Chevy pick up utilize a flanged seal, there was no way in all the cross-over seal books could we find that seal! So we opted for a non-flange style; shouldn’t matter at all, when you (I - myself) install, use a block across the seal to stop install at the hub edge, finish by using several diagonals to ensure the seal face is ‘flat’ across, matching the hub face.
 
Also.. the width of the non-flanged seal will be the width of the flanged seal UNDER the flange (not including the flange).
 
You must log in or register to reply here.
Back
Top Bottom